I usually screw in both bolts but I still have an old laptop that I use on very rare occasions that doesn’t have the screw holes for some reason.
One if somewhat temporary.
Both if I want 1-2% increase in performance.
Both
Both every time but I also haven’t used a VGA cable in at least 15 years.
Lucky you lmao
I still see them once every so often
In fact, I went onsite to a customer who wanted a new PC set up because the old one “wouldn’t boot”. Sure enough the cable was sticking out of the monitor at about a 15deg angle. I pushed the VGA cable in a bit extra hard and it came right back.
I was out of there in about 30min.
I plugged one in today. I left the screws loose. Ironically I moved it between two computers that couldn’t originally do VGA.
I re-organised my leisure desk. My C64 sometimes hooks up to a TFT thanks to my turbo chameleon 64 cartridge.
Today I hooked my C64 up to my CRT instead. I needed that TFT for my Amiga 1200 which has DVI-I out thanks to my indivision flickerfixer. But I have a DVI->VGA adapter to use that same cable.
Ever think you got it unscrewed and accidentally yank the standoff from the PCB?
I work in tech support. I haven’t done this, but a user I’ve worked with absolutely has. I have a photo around here somewhere, if I recall correctly he actually ripped the wires out of the cable lmao!
Edit: the picture. Guess it wasn’t wires out of the cable hah.
How in the fuck?
Like pulling a tooth.
Who does just one? That’s worse than not doing either. Since they’re captive screws, doing just one can force the connector to wedge in crooked. I’ve had issues with tightening one too far before starting the threads on the other. Sometimes you have to go back and forth a couple times
After you properly connected it, sealing just one seems okay, isn’t it?
If you tighten just one side, it can pull the connector in that direction. Think of tightening heatsink screws unevenly on each side.
These seem way more forgiving tho. Up to the point you can connect it hot and working and it’d go nice.
I’ve always screwed them both in very lightly
When I used them, I screwed both in usually.
I loathe when the stand offs come out with the vga cable!!!
It depends.
For my work computer, I screw them in tight, both on the monitor and the DP/VGA adapter.
For stationary devices (like overhead projectors) and extension cords, I screw them in, but not very tight.
For classroom computers, I only screw them in on the monitor and leave them unscrewed on the computer. Students can’t keep their legs calm and often snag the cables. I prefer to let the connectors harmlessly disconnect instead of damaging the graphics card or motherboard.
Both, three rotations after the threads catch.
One or none bears the risk of the connector coming out crooked and bending the pins, causing a potential alignment issue on the next connection and bending them further.
Both, heathens dont bother and they reap what they sow.
Hahaha, I can’t disagree, even as a heathen.
As others have said, depends on how permanent something is
Hand tight, then torque wrench, 7-inch pounds.
For quickly testing something: fuck screws.
For long-term use: both a tight as I can so I barely can unscrew them later because why not.
